软X射线对血液有形成分表面电荷的影响——2、淋巴细胞和血小板膜电荷的变化

软X射线不仅能引起红细胞表面电荷的变化,同时也能导致淋巴细胞和血小板表面电荷下降,表现为照射后它们的电泳率下降。低剂量范围内,这种电荷的变化是暂时性的,照后4小时降到最低点,24小时后恢复到对照的水平。细胞电泳率的下降与辐射剂量相关。淋巴细胞是一个复杂的细胞群,正常状态下,按细胞在电场中泳动速度的快慢,可分为两个组分:快峰为T细胞,慢峰为B细胞。软X射线照射以后,T和B细胞的电泳率皆减慢,频数分布峰值下降,离散度加大。血小板成分单一,电泳率较一致。 从照射浓集的血小板再加回自身血浆中电泳率的下降较照射血浆再加到血小板中的电泳率下降大得多;受照射的血小板在磷酸缓冲液中电泳率下降较在血浆悬液中严重得多;2000 rad照后,悬浮于血浆中的血小板电泳率能恢复,而悬浮于磷酸缓冲液中则不能恢复,三个方面来看,血浆中可能存在抗辐射因子。超氧化物岐化酶能有效地预防血小板电泳率的下降,从而可阻止血小板的凝聚。     

Electrical characterization of very-narrow-gap bulk HgCdTe single crystals by variable magnetic field hall measurements

Variable-magnetic-field Hall measurements (0 to 1.5 T) are performed on very-narrow-gap bulk-grown Hg_1−xCd_xTe single crystals (0.165 ≤ x ≤ 0.2) at various temperatures (10 to 300K). The electron densities and mobilities are obtained within the one-carrier (electrons) approximation of the reduced-con-ductivity-tensor scheme. The present data together with the selected data set reported by other workers exhibit a pronounced peak when the electron mobility is plotted against the alloy composition x-value which has been predicted to be due to the effective-mass minimum at the bandgap-crossing (E_g ≈ 0). The observed position (x ≈ 0.165), height (≈4 x 10² m²Vs), and width (≈0.01 in x) of the mobility-peak can be explained by a simple simulation involving only ionized-impurity scattering. A lower bound of the effective mass is introduced as a fitting parameter to be consistent with the finiteness of the observed electron mobility and is found to be of the order of 10⁻⁴ of the mass of a free electron.     

Mobility Influences on the Capacity of Wireless Cellular Networks

Capacity has always been a major concern in wireless networks. This letter studies the impact of mobility on the overall system capacity in wireless cellular networks. In this letter, we present a simple system model which we developed to capture the inherent relationships among system capacity, new call blocking probability, handoff dropping probability, call terminating probability, and bandwidth utilization rate. We investigate the complex relationship between mobility and capacity‐related parameters. Through simulation, we demonstrate that mobility has a significant impact on capacity and is reversely proportional to the bandwidth reserved for handoff traffic.     

Integrated Personal Mobility Architecture: A Complete Personal Mobility Solution

The high expectations and demand for users to access the Internet from anywhere at anytime has made user mobility an important part of the design and development of the next generation mobile communications and computing. Traditionally user mobility has been divided into two areas: Terminal Mobility and Personal Mobility. In recent years terminal mobility has focused on the movement of the terminal and developed extensions to IP protocols such as Mobile IP. In contrast, personal mobility has only received limited attention, and is somewhat lagging behind. This research has either focussed on personal mobility in communications or personalisation of operating environments. As a result, to date no framework for providing true personal mobility has emerged. In this paper, we introduce a new personal mobility framework called IPMoA (Integrated Personal Mobility Architecture), which integrates both aspects of personal mobility to provide a complete personal mobility solution, and illustrate the viability of this approach through a proof-of-concept implementation.     

Thermal stability of interfaces between metals and InP-based materials

The thermal stability of interfaces between metals (Ni, Pt, Ti, Mo) and III-V compound semiconductors has been investigated by the application of Rutherford backscattering spectrometry. Metal diffusion and interfacial lattice disorder of the semiconductors were analyzed for various metal/semiconductor samples annealed at temperatures up to 500°C. The interfaces of Ni/GaAs and Ti/GaAs were found to be more stable than those of Ni/In-based semiconductors and Ti/ In-based semiconductors, respectively. Faster diffusion of Pt atoms was ob-served in In-and As-containing materials than in P-containing materials. Mo/ semiconductor interfaces were the most stable.     

Growth of high-quality GaSb by metalorganic vapor phase epitaxy

The growth of nominally undoped GaSb layers by atmospheric pressure metalorganic vapor phase epitaxy on GaSb and GaAs substrates is studied. Trimethylgallium and trimethylantimony are used as precursors for the growth at 600°C in a horizontal reactor. The effect of carrier gas flow, V/III-ratio, and trimethylgallium partial pressure on surface morphology, electrical properties and photoluminescence is investigated. The optimum values for the growth parameters are established. The carrier gas flow is shown to have a significant effect on the surface morphology. The optimum growth rate is found to be 3–8 μm/ h, which is higher than previously reported. The 2.5 μm thick GaSb layers on GaAs are p-type, having at optimized growth conditions room-temperature hole mobility and hole concentration of 800 cm² V⁻¹ s⁻¹ and 3·10¹⁶ cm^-3, respectively. The homoepitaxial GaSb layer grown with the same parameters has mirror-like surface and the photoluminescence spectrum is dominated by strong excitonic lines.     

The role of the American Board of Professional Psychology in professional mobility.

This article describes the role of certification by the American Board of Professional Psychology (ABPP) in easing the process by which psychologists move beyond their original jurisdictional boundaries to practice psychology. Meeting the requirements for licensure or certification in the various jurisdictions can be a difficult task because these requirements vary considerably from jurisdiction to jurisdiction. Other mechanisms that are available to facilitate this process include the Certificate of Professional Qualification in Psychology issued by the Association of State and Provincial Psychology Boards and certification by the National Register of Health Service Providers in Psychology. The ABPP certificate/diploma has been regarded by many state psychological associations and state boards of psychology as an appropriate way in which to recognize psychologists who are eligible for licensure/certification in a jurisdiction because of the examination requirements for board certification. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Variability in stepping direction explains the veering behavior of blind walkers.

Walking without vision results in veering, an inability to maintain a straight path that has important consequences for blind pedestrians. In this study, the authors addressed whether the source of veering in the absence of visual and auditory feedback is better attributed to errors in perceptual encoding or undetected motor error. Three experiments had the following results: No significant differences in the shapes of veering trajectories were found between blind and blindfolded participants; accuracy in detecting curved walking paths was not correlated with simple measures of veering behavior; and explicit perceptual cues to initial walking direction did not reduce veering. The authors present a model that accounts for the major characteristics of participants' veering behavior by postulating 3 independent sources of undetected motor error: initial orientation, consistent biases in step direction, and, most important, variable error in individual steps. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Steady-state and transient photoconductivity in hydrogenated amorphous silicon nitride films

Amorphous SiN_x:H films were prepared by the rf glow-discharge decomposition of ammonia/silane gas mixture with varying nitrogen content. The steady-state photoconductivity and its dependence on light intensity have been investigated in a-SiN_x:H as a function of temperature between 100 and 420 K. The electron drift mobility of a set of SiN_x:H samples has been determined from their steady-state photoconductivity and response time measurements. The results suggest that electron drift mobility of the samples was nearly unchanged for a low nitrogen content. Two samples containing lowest nitrogen showed higher photoconductivity than that of unalloyed sample within a temperature range including the room temperature.     

Influence of deposition parameters on hole mobility in polymorphous silicon

Time-of-flight transient photoconductivity measurements reveal a monotonic increase with the deposition pressure in the hole mobility in polymorphous silicon for samples deposited under hydrogen dilution. With helium dilution, a maximum mobility that matches the highest value from H-dilution samples is measured at the intermediate pressure of 1.4 Torr. The deposition rate of those samples is twice the rate for the H-dilution ones. For the samples with the best hole mobilities, the valence-band tail is comparable to the one of standard hydrogenated amorphous silicon.